openbuilds_cnc_machine_2018
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| openbuilds_cnc_machine_2018 [2021/08/02 22:06] – [Electronics] tell | openbuilds_cnc_machine_2018 [2021/08/02 22:37] (current) – [Electronics] tell | ||
|---|---|---|---|
| Line 5: | Line 5: | ||
| Based on the C-Beam Machine kit from Openbuilds.com: | Based on the C-Beam Machine kit from Openbuilds.com: | ||
| + | |||
| + | {{ cbeam-openbuilds.jpg? | ||
| Steve and Jeff assembled it following the video on https:// | Steve and Jeff assembled it following the video on https:// | ||
| Line 21: | Line 23: | ||
| The interface board also has inputs that can be connected to limit and emergency-stop switches. | The interface board also has inputs that can be connected to limit and emergency-stop switches. | ||
| - | The interface uses the [[parallel " | + | The interface uses the [[CNC Parallel Port Mapping | parallel " |
| The interface board is cabled to the parallel printer port on a PC. The parallel port must either be on the motherboard or on a PCI expansion card; USB control is not possible (see the linuxCNC documentation). | The interface board is cabled to the parallel printer port on a PC. The parallel port must either be on the motherboard or on a PCI expansion card; USB control is not possible (see the linuxCNC documentation). | ||
openbuilds_cnc_machine_2018.1627956389.txt.gz · Last modified: 2021/08/02 22:06 by tell