Differences

This shows you the differences between two versions of the page.

--- 2019_i2c_sensors [2019/02/27 23:26] – [I2C multi-sensor breakout panel] tell
+++ 2019_i2c_sensors [2022/02/08 22:12] (current) – [Eastbots Standard 4-pin I2C: same as RoboRIO] tell
@@ Line 18: / Line 18: @@
   * SDA
-.1" COTS cables like this are helpful for wiring:
+.1" COTS cables like this are helpful for wiring: https://www.sparkfun.com/products/10369
 ===== Rev Color Sensor =====
@@ Line 31: / Line 30: @@
 ===== Adafruit VCNL4010 Proximity Sensor =====
+https://www.adafruit.com/product/466
+{{ :adafruit-vcnl4010.jpg?200|}}
+This sensor is useful for sensing distances to a target of about 10-150mm.
+It has 6 pins, which isn't a connector housing size that we normally stock. Besides, we want to adapt to somthing close to the standard pinout.
+But this sensor recommends using  +5v power supply for best output power from its LED light source.  So, we chose this modified pinout using a 5-pin connector, to reduce the chances that 5v and 3.3v sensors can be mixed up accidently:
+  * +5v
+  * GND
+  * no connection on pin 3
+  * SCL
+  * SDA
+Note that the last 4 pins match up exactly with the standard 4 pin connector above, but there's the extra 5v power pin to the outside of the ground pin.
+{{ :vcnl4010-cable.jpg?600 |}}
+TODO redraw this more clearly.
 ===== Adafruit VL53L0X Distance Sensor =====
+https://learn.adafruit.com/adafruit-vl53l0x-micro-lidar-distance-sensor-breakout
+{{ :adafruit-vl53l0x.jpg?200|}}
+This sensor is useful for distances from  about 50mm to 1200mm.  We're planning to use it to detect distance from the robot to the cargo hatch placement sites on the field.
+It runs directly on 3.3v power, so no need for funny business there.  We just need to adapt it to the standard i2c pinout by ignoring the pins we don't need, and putting the rest in the right order.
+{{ :vl53l0x-hookup.jpg?600 |}}
 ===== I2C multi-sensor breakout panel =====
@@ Line 55: / Line 80: @@
 In addition, there's a yellow LED that indicates presence of 3.3v power - proper connection to the 4-pin rio connector.
+==== hookup ====
+NOTE: the black text annotations on this picture are WRONG.
+but the cables in the picture are correct.  we'll replace this photo shortly.
+{{ :i2cboard-hookup-annotated.jpg?400 |}}